This is an interesting article from Switzerland with suggestions for dental practices to stay safer during this COVID-19 pandemic.  It contains some very practical suggestions – most of which are common sense anyway but it is written in an easy to read way with some practical suggestions.

We have had a good read through the article and have noted our own points below in red. We have noted specific products and articles we can assist with that may be able to support you getting your practices back up and running in a safe and efficient environment

Eight ways to keep your dental practice safer during COVID-19 crisis

KRIENS, Switzerland: During the ongoing COVID-19 crisis, the dental profession forms one of the most threatened groups. Close contact with patients, exposure to bodily fluids and the handling of sharp instruments all increase the risk of infection. So what can you do to keep yourself, your dental practice and your patients safe? We have compiled a list of procedures that you can implement in order to contribute to fighting any epidemic, not only the COVID-19 one, in your dental office.

While thorough handwashing and social distancing may be sufficient for the general populace, for dental practitioners, it is necessary to take far more complex precautions. This is because of the three principal modes of virus spread, all of which are relevant to the dental practice:

  • airborne spread—owing to exposure to bodily fluids and generated droplets and aerosol;
  • contact spread—owing to contact with bodily fluids, patient materials, contaminated dental instruments and environmental surfaces; and
  • contaminated surface spread—since coronaviruses can persist on various surfaces for a prolonged time and could contaminate your whole dental office.

A recent study published in the International Journal of Oral Science has investigated the ways in which you can contribute to preventing infection in your dental practice and protect yourself, your staff and your patients from unnecessary viral contamination. These are the most important tips:

1. Evaluate your patients

The first step is identifying suspected cases of COVID-19 in order to avoid extended contact with a potentially infected patient. Screening your patients using a prepared questionnaire and taking adequate steps based on the results and the patient’s body temperature can go a long way. First of all, the body temperature of the patient should be measured. It is strongly recommended that a contact-free forehead thermometer is used for this.

Checking body temperature is a very quick and non invasive way to detect a potential issue. We can supply CONTACT FREE INFARED THERMOMETER that can check a patient’s temperature in just a few seconds.

The following set of screening questions can help identify potential infection:

  1. Do you have a fever or have you experienced a fever within the past 14 days?
  2. Have you experienced a recent onset of respiratory problems, such as a cough or difficulty in breathing, within the past 14 days?
  3. Have you, within the past 14 days, travelled to areas with documented 2019-nCoV transmission?
  4. Have you come into contact with a patient with confirmed 2019-nCoV infection within the past 14 days?
  5. Have you come into contact with people who come from areas with recent documented fever or respiratory problems within the past 14 days?
  6. Are there at least two people with documented experience of fever or respiratory problems within the last 14 days, having had close contact with you?
  7. Have you recently participated in any gathering, meetings, or had close contact with many unacquainted people?

After the screening questionnaire:

  • If the patient replies yes to any of the screening questions, and his or her body temperature is below 37.3°C, you can postpone the treatment until 14 days after the exposure event.
  • If the patient replies yes to any of the screening questions, and his or her body temperature is 37.3°C or higher, the patient should be immediately quarantined, and you should report the case to the infection control department of the hospital or the local health department.
  • If the patient replies no to all the screening questions, and his or her body temperature is below 37.3°C, you can treat the patient with extra protection measures and do your best to avoid spatter or aerosol-generating procedures.
  • Finally, if the patient replies no to all the screening questions, but his or her body temperature is 37.3°C or higher, the patient should be directed to the fever clinic or special COVID-19 clinic for further medical care.

2. Reinforce your hand hygiene

Although appropriate hand hygiene should already be a routine prerequisite, further reinforcement can help mitigate the risk of viral spread.

The study recommends following the two-before and three-after hand hygiene guidelines for dental professionals:

  • before patient examination;
  • before dental procedures;
  • after touching the patient;
  • after touching the surroundings and equipment that have not been disinfected; and
  • after touching the oral mucosa, damaged skin or a wound, blood, bodily fluid, secretion or excreta.

Moreover, all staff should take extra care to avoid touching their own eyes, mouths and noses.

DERMOCOL supplied by Oraltec is in short supply and we are unsure if we will have sufficient stock in the long term. However, we have sourced a very good alternative supplied by a sister company of the Dermocol producer. ALCOGEL is a topical gel used to supplement routine hand washing. ALCOGEL contains 70% ethanol and reduces micro-organisms on the skin.

3. Take personal protective measures

Since airborne droplets are considered to be the main route of infection spread, three-level protective measures are recommended:

  • Standard protection for staff in clinical settings: Disposable working caps, surgical masks and working clothes (white coat), protective goggles or face shields, and disposable latex or nitrile gloves.
  • Advanced protection for dental professionals: Additional disposable isolation clothing or surgical clothes over working clothes in addition to standard protection.
  • Strengthened protection for being in contact with patients with suspected or confirmed COVID-19: If this does occur, and you cannot avoid close contact, special protective outerwear is needed. If not available, working clothes with extra disposable protective clothing over them and impermeable shoe coverings should be added to what has already been listed.

Oraltec can supply you with HAIR COVERS, KN95 MASKS, GOWNS, FACE SHIELDS, GLOVES, APRONS & SHOE COVERS

Guidelines on getting changed into and out of PPE can be found by CLICKING HERE

4. Consider a mouth rinse before dental procedures

Since SARS-CoV-2 is vulnerable to oxidation, preprocedural mouthrinse containing oxidative agents such as 1% hydrogen peroxide or 0.2% povidone-iodine is recommended for the purpose of reducing the salivary load of oral microbes, including potential SARS-CoV-2 carriage. (Note that chlorhexidine, most commonly used as mouthrinse, may not be effective at killing SARS-CoV-2.)

Furthermore, recent studies show that cyclodextrins—broad-spectrum antivirals—show promise for combating viruses. A preprocedural mouthrinse would therefore be most useful in cases when a dental dam cannot be used.

Although the above advice is helpul, a study by Professor Walsh found that using  LISTERINE as a pre procedural rinse is effective, specifically against corona viruses. CLICK HERE to read this article

5. Use dental dam isolation when possible

The use of dental dams can significantly minimise the production of saliva- and blood-contaminated aerosol or spatter, particularly when high-speed handpieces and dental ultrasonic devices are used. The use of a dental dam could reduce airborne particles by 70% within a 1 m radius of the operational field. This benefit is especially valuable now.

When a dental dam is applied, additional high-volume suction should be used (for aerosol and spatter) during the procedures along with regular suction. If dental dam isolation is not possible, manual devices, such as CariSolv and a hand scaler, are recommended for caries removal and periodontal scaling, in order to minimise the generation of aerosol as much as possible.

At Oraltec we have a few options available. We have the classic RUBBER DAM, and we also have HANDI DAM. 

6. Employ anti-retraction handpieces

A high-speed dental handpiece with no anti-retraction valves may suck in and expel debris and fluids. Microbes may further contaminate the air and water tubes within the dental unit and thus potentially cause cross-infection as well.

Compared with that, anti-retraction high-speed dental handpieces can significantly reduce the backflow of oral bacteria and viruses into the tubes of the dental unit. As a result, it is strongly recommended that dental handpieces without an anti-retraction function should not be used at this time and that, as an extra preventive measure, only anti-retraction dental handpieces should be used.

7. Disinfect the clinic environment

While you might be doing your best within your dental clinic, others might not. Therefore, you should take effective and strict disinfection measures in both your clinic settings and public areas. The clinic should be cleaned and disinfected regularly in accordance with available safety protocols, as should the public areas and appliances, including door handles, chairs, desks and lifts.

We are currently in the process of ensuring we have as much stock as possible to support practices by ensuring we have enough infection control stock for everyone’s return to work. Our UNISEPTA RANGE is recognised and used across the country, and we are doing our best to acquire more to ensure stock levels are sufficient. However, in the interim while stocks are out, we will hopefully have a suitable alternative in the near future.

8. Manage your medical waste properly

Remember to dispose of your medical waste, including disposable protective equipment, timeously. Mark the surface of the bags and handle them according to the requirements for the management of medical waste. Also keep in mind that the waste generated by the treatment of patients with suspected or confirmed COVID-19 is regarded as infectious medical waste.

Reusable instruments and items should be properly pre-treated, cleaned, sterilised and stored in accordance with your local protocols.

Reusable instruments will need to be cleaned and disinfected with a sufficient product. MICRO 10 ENZYME 2 from Oraltec is a powerful, tri-enzymatic aldehyde-free concentrated solution, for pre-sterilisation disinfection and cleaning of all dental and surgical instruments.

While none of these precautions can prevent or resolve COVID-19 on their own, all of them can contribute to keeping your dental practice and staff and patients safer and healthier—whether there is an ongoing viral epidemic or not.